Nielk1
/ ExtendInput.DataTools.DualSense.TriggerEffectGenerator.cs
Last active
September 1, 2024 08:02
Factories for all DualSense trigger effects
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| /* | |
| * MIT License | |
| * | |
| * Copyright (c) 2021-2022 John "Nielk1" Klein | |
| * | |
| * Permission is hereby granted, free of charge, to any person obtaining a copy | |
| * of this software and associated documentation files (the "Software"), to deal | |
| * in the Software without restriction, including without limitation the rights | |
| * to use, copy, modify, merge, publish, distribute, sublicense, and/or sell | |
| * copies of the Software, and to permit persons to whom the Software is |
stealth-alex
/ dualsense_haptics_leds_and_more_hid_output_report.txt
Created
January 24, 2021 21:15
DualSense
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| Copy of deleted topic: https://www.reddit.com/r/gamedev/comments/jumvi5/dualsense_haptics_leds_and_more_hid_output_report/ | |
| --- | |
| outputReport[0] = 0x02; // report type | |
| outputReport[1] = 0xff; // flags determiing what changes this packet will perform | |
| // 0x01 set the main motors (also requires flag 0x02); setting this by itself will allow rumble to gracefully terminate and then re-enable audio haptics, whereas not setting it will kill the rumble instantly and re-enable audio haptics. | |
| // 0x02 set the main motors (also requires flag 0x01; without bit 0x01 motors are allowed to time out without re-enabling audio haptics) | |
| // 0x04 set the right trigger motor |
nealfennimore
/ wireguard.conf
Last active
September 12, 2024 12:40
Wireguard VPN - Forward all traffic to server
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| # ------------------------------------------------ | |
| # Config files are located in /etc/wireguard/wg0 | |
| # ------------------------------------------------ | |
| # ---------- Server Config ---------- | |
| [Interface] | |
| Address = 10.10.0.1/24 # IPV4 CIDR | |
| Address = fd86:ea04:1111::1/64 # IPV6 CIDR | |
| PostUp = iptables -A FORWARD -i wg0 -j ACCEPT; iptables -t nat -A POSTROUTING -o eth0 -j MASQUERADE; ip6tables -A FORWARD -i wg0 -j ACCEPT; ip6tables -t nat -A POSTROUTING -o eth0 -j MASQUERADE # Add forwarding when VPN is started | |
| PostDown = iptables -D FORWARD -i wg0 -j ACCEPT; iptables -t nat -D POSTROUTING -o eth0 -j MASQUERADE; ip6tables -D FORWARD -i wg0 -j ACCEPT; ip6tables -t nat -D POSTROUTING -o eth0 -j MASQUERADE # Remove forwarding when VPN is shutdown |