Hardware Setup / Proxmox Base Install

this gist is part of this series

Hardware Setup (perform on all 3 nodes)

• Connect all 3 NUC to power etc
• Disable secure boot in BIOS on all nodes
• Connect all 3 TB4 cables in a rinng topology:

using the numbers printed on the case of the intel13 nucs connect cables as follows (this is important):
- node 1 port 1 > node 2 port 2
- node 2 port 1 > node 3 port 2
- node 3 port 1 > node 1 port 2

• Prepare bootable usb key by downloading proxmox iso and tools such as 'rufus'
• Boot from USB

Proxmox Base Install (repeat on each node)

• choose GUI (why not!)
• accept terms
• choose the SSD NOT the NVME for the install
• set country, keyboard, etc
• choose a password (this will be for the user - root) and set email
• choose enp86s0 as the management interface (on proxmox 8 you will see the thundebolt netwrok too if cables are connected)
• set a name for each node - i used pveX.mydomain.com where X = the node number i wanted
• set fixed IPv4 address for the management network
  • 192.168.1.81/24 for node 1
  • 192.168.1.82/24 for node 2
  • 192.168.1.83/24 for node 3
• set external DNS server and gateway
• let the software partition disk as it sees fit
• review summary page
• removed the USB key and reboot when prompted

You should now have 3 nodes. Each should be accessible over the network with the IP addresses you specified. e.g 192.168.1.81:8006, 192.168.1.82:8006, 192.168.1.83:8006

The default username is root and you use the password you defined earlier. Consider making constrained users and doing security properly. I won't be doing that, i will be using root as this a PoC.

Set Package Repositories (only needed if you don't use a subscription)

Note: i will not be using enterprise packages as this is a PoC for evaluation / homeLab purposes only

In node-name > updates > repositories perform the following:

• add No-Subscription
• add Ceph Quincy No-Subscription
• disable pve-enterprise
• disable ceph-quincy enterprise too

Open the shell and perform apt update && apt upgrade to update all components and then reboot.