Standalone prometheus config for using with KubeGraf. Supports
prometheus.io/scrape
, prometheus.io/port
and prometheus.io/path
annotations for pods and services.
# Pin assignments: https://reprap.org/wiki/SMART_RAMPS | |
[stepper_a] | |
step_pin: ar54 | |
dir_pin: ar55 | |
enable_pin: !ar38 | |
# X-max endstop | |
endstop_pin: ^ar2 | |
position_endstop: 431.8345625 | |
angle: 209.67 | |
# 32 microsteps |
Another crown in ImplicitCAD. See http://3dtoday.ru/questions/nevidannaya-treshchetka/
Crown in OpenSCAD, see http://3dtoday.ru/questions/vopros-po-modelirovaniyu/
PCB heat bed for Make3D D2 Mini delta 3D printer.
Moved here: https://github.com/lorf/make3d-d2-mini-pcb-heat-bed
The clock kit is from here. The kit comes without the case, suitable case can be purchased here.
The files I received from the seller are included.
The MCU used is STM8S003K3. 7-segment displays - KYX-1106BGG (can't find the datasheet for this exact part, here is the datasheet for the similar displays, also included here as TOS-1106BS-B.pdf
).
Quick directions: R16-R23 - 220R (resistance may vary for different displays); R1,R7-R10,R29 - 10k; R11-R15 - 2.2k; C11,C13 - 20pF; C1 - 0.1uF (marked 105); C2,C4,C6 - 10nF (marked 104). Buzzer plus pin towards power connector. DS3 should be placed decimal point up.
// PSKEY_BDADDR | |
&0001 = 00XX XX52 00XX XXXX | |
// PSKEY_COUNTRYCODE | |
&0002 = 0000// North America and Europe | |
// PSKEY_CLASSOFDEVICE | |
&0003 = 0000 0000 | |
// PSKEY_DEVICE_DRIFT | |
&0004 = 00fa | |
// PSKEY_DEVICE_JITTER | |
&0005 = 000a |