Last active
March 3, 2023 14:28
-
-
Save Palakis/cf370a19d2a9da38ac0d88776498450c to your computer and use it in GitHub Desktop.
ESPhome on Action LSC Motion Sensor - Tuya TYWE3S (ESP8266-based)
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
# This device has two chips: | |
# - an ESP8266-based WiFi Module that talks to Tuya's cloud service (when running the stock firmware) and the on-board MCU. | |
# - an unmarked Tuya microcontroller (a.k.a MCU) that acts as a power management chip and wakes up the WiFi Module | |
# when motion is detected by the PIR sensor. The WiFi Module has to talk to the MCU upon power-on to prevent immediate power-off. | |
substitutions: | |
device_name: CHANGEME | |
esphome: | |
name: '${device_name}' | |
platform: ESP8266 | |
board: esp_wroom_02 # TYWE3S modules have 2MB of on-board flash | |
on_boot: | |
then: | |
- uart.write: [0x55, 0xAA, 0x00, 0x02, 0x00, 0x01, 0x04, 0x06] # report "wifi ok, connected to router and to cloud" | |
- wait_until: mqtt.connected | |
- binary_sensor.template.publish: | |
id: pir_workspace_motion_detected | |
state: ON | |
- delay: 1s | |
- binary_sensor.template.publish: | |
id: pir_workspace_motion_detected | |
state: OFF | |
- uart.write: [0x55, 0xAA, 0x00, 0x02, 0x00, 0x01, 0x05, 0x07] # power off wifi module | |
wifi: | |
ssid: !secret wifi_ssid | |
password: !secret wifi_pass | |
fast_connect: True | |
# Disable serial logging | |
logger: | |
baud_rate: 0 | |
# Enable OTA updates | |
ota: | |
password: !secret mgmt_pass | |
time: | |
- platform: sntp | |
id: sntp_time | |
uart: | |
baud_rate: 9600 | |
tx_pin: GPIO1 | |
rx_pin: GPIO3 | |
mqtt: | |
broker: !secret mqtt_broker | |
username: !secret mqtt_username | |
password: !secret mqtt_pass | |
discovery: True | |
# TODO detect motion from MCU messages | |
binary_sensor: | |
- platform: template | |
id: pir_workspace_motion_detected | |
name: 'PIR Workspace - Motion Detected' | |
device_class: motion |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
@Palakis
This is amazing !
This is my chance to get rid of the default tuya integration issues !
Can you give more information on how you flashed the chip ?
Any change there was also an analog pin assigned for measuring the battery level ?
I believe it will be probably be pin 2 since this is a 10-bit-precision SAR ADC