This tutorial for setting up Ubuntu Server (RPi 3B) as Wifi access point
The main steps can be listed as following:
- Install required packages
- Setup hostapd
- Setup DNSmasq
- Configure AP IP Address
#Wireless Penetration Testing Cheat Sheet
##WIRELESS ANTENNA
root@uceka:~# ifconfig wlan0mon down
root@uceka:~# iwconfig wlan0mon mode monitor
root@uceka:~# ifconfig wlan0mon up
#!/bin/bash | |
# | |
# This version uses September 2017 august stretch image, please use this image | |
# | |
if [ "$EUID" -ne 0 ] | |
then echo "Must be root" | |
exit | |
fi |
(Serial port or com port? - Serial ports are often refered as COM ports. It is the same to be short. You can read abut it in the Wiki article )
#include <IRremote.h> | |
/* | |
Send infrared commands from the Arduino to the iRobot Roomba | |
by probono | |
2013-03-17 Initial release | |
/* | |
A trivial Arduino sketch to mimic iRobot Virtual Wall for Roomba | |
---------------------------------------------------------------- | |
Based on information found at: | |
http://sites.google.com/site/irobotcreate2/createanirbeacon | |
Uses "A Multi-Protocol Infrared Remote Library for the Arduino": | |
http://www.arcfn.com/2009/08/multi-protocol-infrared-remote-library.html |