I hereby claim:
- I am cscashby on github.
- I am babelmonk (https://keybase.io/babelmonk) on keybase.
- I have a public key whose fingerprint is 965C FD43 A02E 2C80 950C ED28 4B0E D831 33DE 5C63
To claim this, I am signing this object:
--- | |
substitutions: | |
devicename: "plug-XXX" | |
upper_devicename: "Plug XXX" | |
# Higher value gives lower watt readout | |
current_res: "0.002452" | |
# Lower value gives lower voltage readout | |
voltage_div: "939" | |
# GPIO config | |
sel_pin: GPIO12 |
# This file contains common pin mappings for the Fysetc Spider board. | |
# To use this config, the firmware should be compiled for the STM32F446. | |
# When calling "menuconfig", enable "extra low-level configuration setup" | |
# and select the "12MHz crystal" as clock reference | |
# For flashing, write the compiled klipper.bin to memory location 0x08000000 | |
# See docs/Config_Reference.md for a description of parameters. | |
## Voron Design VORON2 250/300/350mm Spider TMC2209 UART config |
# This file contains common pin mappings for the Fysetc Spider board. | |
# To use this config, the firmware should be compiled for the STM32F446. | |
# When calling "menuconfig", enable "extra low-level configuration setup" | |
# and select the "12MHz crystal" as clock reference | |
# For flashing, write the compiled klipper.bin to memory location 0x08000000 | |
# See docs/Config_Reference.md for a description of parameters. | |
## Voron Design VORON2 250/300/350mm Spider TMC2209 UART config |
/interface ethernet | |
set [ find default-name=ether1 ] name=cam1 | |
set [ find default-name=ether2 ] name=cam2 | |
set [ find default-name=ether3 ] name=cam3 | |
set [ find default-name=ether4 ] name=cam4 | |
/interface list | |
add name=CAMERAS | |
/routing table | |
add fib name=cam1 | |
add fib name=cam2 |
I hereby claim:
To claim this, I am signing this object: